Komatsu — 4.7.6.g CHECKING AND ADJUSTING THE A/C COMPRESSOR BELT TENSION (Optional)

MAINTENANCE PLAN 4.7.6.g CHECKING AND ADJUSTING THE A/C COMPRESSOR BELT TENSION (Optional) If the pressure exerted is approximately 10 kg, the resulting de- flection must be approx. 5-6 mm. When the belt is new, the resulting deflection must be approx. 4 mm. If the resulting deflection exceeds the values indicated, proceed as follows: 4 1 - Remove the belt guard (4). 2 - Loosen the screw (5) that fastens the cam (6). 3 - Loosen the screw (7) that fastens the compressor (2). 4 - Loosen the nut (8) and tighten the screw (9) to achieve the correct tension.

5 - Hold the belt in this position using the screws (7) and the nut RKAA1772 + + 211 DANGER   • The adjustment of the belt tension is a mechanical opera- tion and must be carried out without working on the air conditioning system. • Carry out this check with cold engine. The compressor belt can be reached after opening the engine hood (see «3.5.1 ENGINE HOOD»). The check is manual and consists in exerting pressure on the belt (1) at the centre of the section between the compressor (2) and 56 , *     DANGER (8). IMPORTANT 9 • If the belt is worn or in case of doubt regarding its condi- tions, change it and check its tension again after a few hours of operation. 8 6 5 RKAA1790