Komatsu — 4.7.8.c CHECKING THE HYDRAULIC OIL LEVEL

MAINTENANCE PLAN 4.7.8.b DRAINING THE FUEL TANK When draining the fuel tank, avoid spilling fuel, since this may cause fires. If some fuel is accidentally spilled, clean the dirty area immediately, in order to prevent it from getting slippery and to avoid fires. Do not smoke, nor use naked flames when carrying out this operation. Wear waterproof gloves and safety goggles, as fuel may be sprayed out during this operation. This operation must be carried out when the fuel level on the indicator is just above the reserve mark. Its purpose is to let out any impurity and condensate that may have accumulated in the fuel tank, without letting any air into the engine fuel supply lines.

1 - To let the condensate flow out, loosen the drain plug (1) until 4.7.8.c CHECKING THE HYDRAULIC OIL LEVEL The oil level must be checked when the oil is cold, with the machine on level ground and in travel posi- tion. If it is necessary to top up, stop the engine and release the residual pressure from the tank by slowly loosening the filler cap (2). 215 DANGER ATTENTION no more water is present in the fuel that flows out.

IMPORTANT • The tank must be drained before starting the engine, at temperatures over 0°C; when the temperature is below 0°C, the tank must be drained at the end of work or in any case with the machine at a temperature of 40–45°C, in order to prevent the condensate from freezing when the tempera- ture drops, thereby making the draining operation impossi- ble. • The condensate and the impurities that may have accumu- lated inside the tank must be eliminated before refuelling. 1 RKAA1850 DANGER The oil level must reach half of the sight gauge (1) on the tank, where the MIN. and MAX. levels are marked.

If the oil level is near the lower edge of the sight gauge (MIN), top up through the filler (3) using hydraulic oil of the type prescribed (see «4.3 FUEL, COOLANT AND LUBRICANTS»); then put back the filler cap (2). 2 3 IMPORTANT 2 • Do not add oil over the MAX. mark (upper edge of the sight gauge), as this would make the oil flow out. • If you notice a constant, unusual decrease in the oil level, contact your Komatsu Utility Dealer. RKAA1730