Komatsu — 4.7.8.d CHANGING THE HYDRAULIC OIL DRAIN FILTER

MAINTENANCE PLAN 4.7.8.d CHANGING THE HYDRAULIC OIL DRAIN FILTER The filter is positioned on the hydraulic system drain outlet and it holds the metal particles that come off the various components due to their wear. To replace the filter, proceed as follows: 1 - Slowly loosen the filler cap (1) to release any residual pres- sure from the tank and then remove the cap. 2 - Remove the screws (2) and the filter cover (3). 3 - Remove the cartridge (4) and the spring (5). 4 4 - Clean the magnetic rings (6) that are positioned on the cover (3) to block the metal particles. 5 - Change the cartridge (4).

6 - Reassemble the whole by proceeding in the reverse order RKAA1820 3 6 7 RKAA1860 216 DANGER • Soon after the machine has been stopped the hydraulic oil is very hot; allow it to cool down to 40–45°C before chang- ing it. • The hydraulic system is under pressure; slowly loosen the filler cap to release any residual pressure. • Filters are considered special waste and must be collected and disposed of in accordance with the anti-pollution regu- lations in force. 1 3 2 RKAA1112 DANGER and make sure that the gasket (7) of the cover (3) is not dam- aged and is correctly housed in its seat.

ATTENTION • Thoroughly check the inside of the filter; if there is an unu- sual quantity of metal particles due to wear, contact your Komatsu Utility Dealer immediately. 5 RKAA1830 ATTENTION