MAINTENANCE PLAN 4.7.8.e DRAINING CONDENSATE FROM THE OIL TANK (Only for machines in which synthetic biodegradable oil HEES is used) After stopping the engine, with the machine in travel condi- tion, release any residual pressure from the tank by slowly loosening the filler cap. Let the oil cool down to 40–45°C before carrying out this maintenance operation. If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery. Oil is considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. at temperatures above 0°C.
When the temperature is below 0°C, the draining procedure should be carried out at the end of work or in any case with the machine at operating temperature (40–45°C), to prevent the condensate the con- densate from freezing, thereby making the draining opera- tion impossible. 2 RKAA1840 217 DANGER The purpose of this operation is to let any condensate deposited on the bottom of the tank flow out. To do that, perform the following steps in the sequence indicated: 1 - Loosen the filler cap (1) to release any residual pressure from the tank. 2 - To let the condensate flow out, loosen the drain plug (2) until no more water is present in the fuel that flows out. 3 - Tighten the plug (2).
1 IMPORTANT • Condensate should be drained before starting the engine, RKAA1113