MAINTENANCE PLAN 4.7.8.f CHANGING THE ENGINE OIL Change the oil with the machine parked on level ground and with the boom fully retracted. Soon after the machine has been stopped, the engine is very hot and may cause burns; let the engine cool down to 40-45°C before draining the oil. The oil that may be spilled during the oil change will make the ground slippery, therefore, use anti-slip shoes and immediately remove any trace of oil from the floor. Oils and filters are considered special waste and must be collected and disposed of according to the an- ti-pollution regulations in force. When changing the engine oil, change also the oil filter (see «4.7.8.g CHANGING THE ENGINE OIL FILTER»).
Proceed as follows: 1 - Open the engine hood (see «3.5.1 ENGINE HOOD»). 2 - Remove the drain plug (1) of the oil pan, gathering the used oil that flows out into a container with suitable capacity. While the oil flows out, remove the filler cap (2), so that the oil can flow out freely. 3 - Change the filter (see «4.7.8.g CHANGING THE ENGINE OIL FILTER»). 4 - Tighten the plug (1) onto the oil pan and add the prescribed quantity of new oil, using the dipstick (3) to make sure that the oil reaches the MAX. level. 1 5 - Put back the filler cap (2), start the engine, let it run for 5 min- utes and then stop it. Check the level again and top up if necessary. RKAA1870 6 - Close the engine hood.
Use oil suitable for the ambient temperature. (See «4.3 FUEL, COOLANT AND LUBRICANTS»). 2 RKAA1880 MAX. 3 MIN. RKAA1890 218 DANGER