MAINTENANCE PLAN 4.7.8.h CHECKING THE CHAINS FOR OXIDATION (Only for the 3-section boom version) dicates that a chain is corroded and has therefore lost its frame. This is a visual check and consists in spotting signs of oxidation on the extension and retraction chains. For the inspection, proceed as follows: 5 1 - Remove the screws and the rear cover (1) of the main boom section (2).
2 - While the operator slowly extends the boom sections, inspect the side links of the retraction chain (3) and the sides of the rollers; the presence of lubricant with traces of oxide, or, even worse, of oxide only, means that the chains need the mainte- nance operations that must usually be performed EVERY 500 HOURS. 7 6 RKAA1612 The same check must be carried out also on the boom extension upper chains (4), by proceeding as follows: 8 9 1 - With boom sections completely extended, stop the engine. 2 - Remove the screws (5), the grease nipple (6) and the casing (7). 3 - Remove the guard (8).
4 - Inspect the extension chains (9) for traces of oxidation; the presence of lubricant with traces of oxide or of oxide only means that the chains need the maintenance operations that must usually be performed EVERY 500 HOURS. RKAA1641 Do not lubricate oxidized chains, as the lubricant promotes the re-penetration of the ejected oxide and increases wear on the driving rollers and the joint. 220 DANGER • This is a visual check and must be performed when the chains are moving slowly. Keep your hands away from the chains. • At the end of this check, before using the machine, or in any case before retracting the boom sections, reassemble and fasten all the chain protection guards.
Failure to comply with these instructions can lead to se- vere hazard. • The presence of oxide or powder oxide in the lubricant in- 2 1 RKAA1522 DANGER safety characteristics as defined by the manufacturer. If this defect is noticed, contact your Komatsu Utility Dealer immediately for a thorough inspection and, if necessary, have the chain replaced. Select the WORK operating mode and position the machine on level ground, with boom sections fully retracted and lowered, frame levelled (if the relevant device is provided), parking brake applied and stabilizers (if provided) lowered to the ground.
3 NOTE • If the machine is not equipped with stabilizers, place a safety block in central position under the front part of the RKAA1930 ATTENTION