Komatsu — 4.7.8.i CHECKING AND TIGHTENING THE BOOM CHAINS (Only for the 3-section boom version)

MAINTENANCE PLAN 4.7.8.i CHECKING AND TIGHTENING THE BOOM CHAINS (Only for the 3-section boom version) NOTE A flapping noise between the chain and the boom probably indicates that the chains need tightening. Before starting this check, remove the front equipment and place the machine on firm and level ground (see «3.7.1 PARKING ON LEVEL GROUND»). The chain checking and tightening procedure must be carried out with boom sections fully extended. As a safety precaution, position under the intermediate boom a stand capable of supporting the entire boom before extending the boom sections and lower the stabilizers to the ground, if provided. Do not rest the boom so as to it can run freely.

At the end of the tension adjustment procedures, before using the machine, or in any case before re- tracting the boom sections, reassemble and fasten all the chain protection guards. Failure to comply with these instructions can lead to severe hazard. If the machine isn’t equipped with stabilizers, place a safety block in central position under the front part of the frame. Before checking the chains, lubricate the sliding pads (see «4.7.3.a LUBRICATING THE ARTICULATED JOINTS AND THE PADS»).

4 5 6 7 3 2 1 8 RKA02260 B A 1 - Final boom section 2 - Final section pad 3 - Intermediate section pad 4 - Chain guard 5 - Extension chain 6 - Tie rod 7 - Extension chain adjusting nuts 8 - Main boom section base 9 - Intermediate boom section 10 - Boom retraction chain 11 - Retraction chain adjusting nut 221 DANGER ATTENTION