Komatsu — 4.7.8.n CHECKING THE WHEEL NUT DRIVING TORQUE

MAINTENANCE PLAN 4.7.8.l CHECKING THE CLEARANCE OF THE CHAIN DRIVING GEAR BUSHINGS (Only for the 3-section boom version) This maintenance operation must be carried out together with those described in the previous paragraph, with the machine parked in the same conditions as described above. The inspection is carried out after removing the guards (1) and (2), with a feeler gauge or with gauged wires introduced between bushing and pin on the side where the chain doesn't rest. If the clearance reaches 1 mm, contact your Komatsu Utility Deal- er.

1 RKAA1523 2 RKAA1614 4.7.8.m CHECKING THE SLIDING BLOCK CLEARANCE This check requires the removal of some parts and good knowledge of the operating methods is therefore essen- tial. Contact your Komatsu Utility Dealer to have this inspection carried out. During the maintenance service to be car- ried out EVERY 500 HOURS, they will also adjust any boom block clearance due to settling or wear. 4.7.8.n CHECKING THE WHEEL NUT DRIVING TORQUE 228 This check serves to restore the correct driving torque of the wheels on the hubs. The driving torque must be checked by means of a torque wrench (1) set according to the values indicated in paragraph «4.4.1 STANDARD DRIVING TORQUES».

IMPORTANT • Do not increase the specified driving torque and keep it within the prescribed ranges. • Do not lubricate the thread when checking the driving torque. 1 RKAA1740