Komatsu — 4.7.9.a CHANGING THE FRONT AND REAR AXLE OIL

MAINTENANCE PLAN 4.7.9 MAINTENANCE EVERY 1000 HOURS OF OPERATION OR EVERY YEAR Carry out the following maintenance operations together with those to be performed EVERY 50, 100, 250 and 500 HOURS. 4.7.9.a CHANGING THE FRONT AND REAR AXLE OIL 1 - Remove the drain plug (2) and let the used oil flow out com- pletely. While the oil flows out, remove the plug (1). Use a 12mm hexagon wrench. 2- Once the oil has been drained, put back the plug (2) and add oil of the prescribed type through the plug hole (1), until reaching the level corresponding to the lower edge of the hole itself. 3- Put back the plug (1).

FINAL REDUCTION GEAR 1 - Move the machine until the plug (3) is in low position on the vertical axis. 2 - Remove the plug (3) and let the used oil flow out. Use a 12mm hexagon wrench. 3 - Once the oil has been drained, move the machine until the plug (3), which serves also as level indicator, is positioned on the horizontal axis. 4 - Add oil of the prescribed type until reaching the lower edge of the hole itself. 5 - Put back the plug (3). Carry out some forward and backward movements, stop the ma- chine and check the levels again. Always use oil of the prescribed type. (See «4.3 FUEL, COOL- ANT AND LUBRICANTS».

229 DANGER • Oil is considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. This operation must be carried out with the machine positioned on level ground and at operating temperature, so that the oil be- comes fluid and can easily be drained, which facilitates the elimi- nation of any suspended solid particles. DIFFERENTIAL 1 2 RKAA1970 DANGER 3 RKAA1980 3 RKAA1990