MAINTENANCE PLAN 4.7.9.c CHANGING THE HYDRAULIC TRANSMISSION FILTER Soon after the machine has been stopped the transmission unit is very hot and may cause burns; let the machine cool down before changing the filter. 1 2 The oil that may be spilled during the replacement of the fil- ter will cause the floor to become slippery: use anti-slip shoes and immediately remove any trace of oil from the floor and the transmission unit. Oils and filters are considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. RKAA2030 Carry out this operation whenever the transmission oil is changed. Proceed as follows: 3 MAX.
1- While the transmission oil is being drained, use the special wrench provided to unscrew and remove the old filter (1). MIN. 3 3 - Clean the contact surface between the gasket and the filter support (2). 4 - Lubricate the gasket, fit it in its seat and screw the filter thor- oughly until it touches the gasket. 5 - Give another half turn by hand. RKAA2011 6 - Start the engine, let it idle and let the oil warm up until reach- ing the operating temperature. 7 - Top up until reaching the MAX. mark on the dipstick (3). (See «4.7.6.d CHECKING THE TRANSMISSION OIL LEVEL»).
4.7.9.d CHECKING THE ENGINE COOLANT LEVEL AND TOPPING UP For information on this maintenance operation, see «4.7.2.c CHECKING THE ENGINE COOLANT LEVEL» and «4.7.2.d CHECKING THE RADIATOR FLUID LEVEL». 231 DANGER