Komatsu — 4.7.10.c CHANGING THE COOLANT

MAINTENANCE PLAN 4.7.10 MAINTENANCE EVERY 2000 HOURS OF OPERATION OR EVERY 2 YEARS Carry out these maintenance operations together with those to be performed every 50, 100, 250, 500 and 1000 HOURS. 4.7.10.a CHECKING THE ALTERNATOR AND THE STARTER Have this inspection carried out by your Komatsu Utility Dealer. 4.7.10.b CHANGING THE ALTERNATOR BELT This procedure must be carried out by qualified personnel. Have this operation performed by your Komatsu Utility Dealer. 4.7.10.c CHANGING THE COOLANT 5 - Start the engine and let it run at accelerated idle speed for a few minutes; check the level again and top up before putting back the upper cap (1).

6 - Fill the expansion tank (4) until reaching the maximum level. 4 7 - Close the engine hood. RKAA2050 232 DANGER 1 1 • Soon after the machine has been stopped the coolant is very hot and under pressure and it may cause serious burns; let the engine cool down until it reaches approxi- mately 40–45°C before changing the coolant. • Slowly loosen the radiator cap, in order to release any re- sidual pressure. • Coolant is considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. 2 RKAA1751 DANGER IMPORTANT • The change of permanent coolant does not require any washing cycle to remove deposits from the circuit.

1 - Open the engine hood (see «3.5.1 ENGINE HOOD»). 2 - Loosen and remove the upper cap (1) of the radiator (2). 3 - Loosen and remove the radiator drain plug (3) and let the flu- id flow out. Drain the expansion tank (4) while the fluid flows out. 4 - Put back the drain plug (3) and fill the radiator with new fluid (see «4.3 FUEL, COOLANT AND LUBRICANTS»). 3 RKAA2040