MAINTENANCE PLAN 4.7.10.d CHANGING THE BRAKING SYSTEM OIL Oil spilled on the floor may cause the floor to become slippery; immediately clean any dirty area. Oil is considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. Before changing the braking system oil, it is advisable to brake a few times in order to warm up and fluidize the oil and therefore facilitate draining. The oil change and the bleeding of the braking system must be carried out with the machine positioned on level ground, with boom fully retracted and lowered and parking brake applied. Drain the oil and wash the system, proceeding as follows:
1 - Apply a small pipe for the collection of the oil to the drain screws (1) and loosen them. 2 - Remove the front guard (2) and the cap (3) from the reservoir (4). 3 - Operate the brake pedal until the oil contained in the reser- voir (4) runs out. 4 - Fill the reservoir (4) with new oil and keep pressing the pedal; fill the reservoir (4) more than once until the used oil (about 0.8 l) has been changed completely; bleed any residual air. (See the following paragraph). For details on the oil to be used, see «4.3 FUEL, COOLANT AND LUBRICANTS» 1 RKAA1801 2 RKAA2060 4 3 RKAA2070 233 DANGER