Komatsu — 4.7.10.d CHANGING THE BRAKING SYSTEM OIL

MAINTENANCE PLAN BLEEDING THE BRAKING CIRCUIT This operation is important, since it ensures the braking efficiency and power of the machine. Proceed as follows: 1 - Make sure that the oil in the braking system reservoir (4) reaches the maximum level. 2 - Start the engine and let it idle. Press the brake pedal thoroughly and, while keeping it pressed, loosen the drain screw (1) of the relevant brake as- sembly until the pedal reaches the end of stroke. 3 - While keeping the pedal completely pressed, tighten the drain screw (1).

4 - Release the brake pedal, wait a few seconds and repeat the operations described above until no air bubbles can be no- ) The bleeding procedure must be carried out on both axles (four braking assemblies). Check the oil level in the braking system reservoir fre- quently and top up whenever the oil level is near the mini- mum mark. 2 To top up, use only new oil of the prescribed type. RKAA2060 234 ticed in the oil that flows out of the drain screw (1). 5 - Carry out the same procedure on the remaining brake as- semblies. 6 - After bleeding, start the machine and check the braking per- formance (see «4.7.2.g CHECKING THE SERVICE BRAKES»); if necessary, repeat the bleeding procedure.

7 - Put back the front guard (2). 1 IMPORTANT • When bleeding the system, apply a small pipe to the screws (1), in order to collect the oil. RKAA1801