MAINTENANCE PLAN 4.7.10.e CHANGING THE HYDRAULIC OIL AND CLEANING THE INTAKE FILTER After stopping the engine, with the machine positioned on level ground, boom fully retracted and lowered and parking brake applied, release any residual pressure from the tank by slowly loosening the filler cap. Let the oil cool down to 40–45°C before carrying out this maintenance operation. Immediately clean any area dirty with oil. Oil is considered special waste and must be collected and disposed of according to the anti-pollution regulations in force. 1 1- Remove the filler cap (1). 2- Remove the drain plug (2) and let the oil flow out, gathering it into a container with suitable capacity.
3- Loosen the clamps and disconnect the intake coupling (3). 4 - Loosen and remove the screws and remove the flange (5) RKAA2080 clamps. 8- Change the drain filter (see «4.7.8.d CHANGING THE HY- DRAULIC OIL DRAIN FILTER». 9- Put back the drain plug (2) and fill the oil tank with the pre- scribed oil until reaching the correct level. 10- Open the engine hood. 11- Loosen the bleed plug (8) that is positioned on the hydraulic pump, until no air bubbles can be observed in the oil that flows out. Tighten the bleed plug (8) and close the engine hood. 12 - Put back the filler cap (1), start the engine and operate the machine making each piston move several times in order to bleed the system.
7 5 6 RKAA1920 235 DANGER complete with gasket (6) and filter (7). 5- Clean the filter (7) using light solvents (kerosene, diesel oil, etc.); dry the filter with low-pressure compressed air (max. 3 bars). 2 IMPORTANT • Carefully check the condition of the filtering element grid and if there is any doubt about its soundness, change it. 6- Position the gasket (6) and put back the flange (5) complete with filter (7). 7 - Connect the intake coupling (3) and secure it with the 5 4 3 RKAA1841 Stop the machine in maintenance position, check the oil level again and top up if necessary. Always use oil of the prescribed type (See «4.3 FUEL, COOLANT AND LUBRICANTS»).
IMPORTANT • Do not start the engine with empty tank, since this would certainly damage the pump. 8 RKAA2120