GENERAL PRECAUTIONS 2.2.6 GETTING ON AND OFF THE MACHINE Do not jump on or off the machine when it is at rest, nor when it is moving. When getting on or off the machine, always use the handles and the safety ladders; get on and off the machine very careful- ly. Do not hold, nor rest on the steering wheel or the gearshift le- ver. When getting on and off the machine, always maintain three points of contact (holding or resting points), in order to avoid losing your balance and falling down. Tighten the ladder connection screws if they are loose and clean the handles and the steps if they are dirty with oil or grease. Carefully clean the cab floor if it is dirty with oil, grease, mud or rubble.
RKAA0490 2.2.7 CHECKING THE REAR-VIEW MIRRORS Working without checking the back of the machine is danger- ous, since the machine may hit persons who are incautiously standing in the work area, fixed obstacles or manoeuvring vehi- cles. Make sure that the rear-view mirrors are clean and correcly po- sitioned; they must allow the operator to see the rear of the ma- chine with no need to move his trunk with respect to the normal work position. If the rear-view mirrors should move or break during work, stop the machine immediately and fasten or change them. RKAA2270 RKAA2280 35