PRECAUTIONS TO BE TAKEN DURING WORK 2.4 PRECAUTIONS TO BE TAKEN DURING WORK 2.4.1 WHEN STARTING THE ENGINE Before getting on the cab, walk around the machine and check if there are leakages (fuel, engine coolant, oil), damage to the cab, lights and indicators, loose screws, damaged tyres, etc. Make sure that there are no people or obstacles along the trajectory of the machine. Get on the cab and make sure that there is no warning plate signalling that the machine cannot be started. Make sure that the parking brake has been applied. Make sure that the gearshift-reverse lever is in neutral (N).
Turn the ignition key until it makes a first click and check the correct operation of the indicator lights for machine lights, direction indicators, horn, alarms and Sli-safe Load Indicator (see «3.2.5 MACHINE CONTROLS» pos. 7 - SLI-SAFE LOAD INDICATOR). Adjust the position of the seat, considering that the ideal position for the operator is when he is seated with his back resting on the backrest and at the same time he can press the brake pedal completely. Adjust the rear-view mirrors. Fasten the safety belt and adjust its length, if necessary. Do not allow anyone to get on the machine or enter the cab.
Start the engine (see «3.6.2 STARTING THE ENGINE») and warn the persons in the vicinity by sounding the horn. Turn the steering wheel in both directions and check the movements of the front wheels. 2.4.2 RULES FOR TRAVELLING ON ROADS Before travelling on roads, it is necessary to study and plan the route, checking the road width, the presence of tight curves, the bearing capacity of the bridges, the presence of ditches or of excavations filled with earth that isn’t well compacted, etc. To travel on roads it is necessary to remove or fold and secure the forks and to place the lifting equipment in a safe position (see «3.12.7 PREPARING THE MACHINE FOR TRAVELLING ON ROADS»).
If the machine is fitted with a loader and this protrudes from the machine outline, beside the teeth guards it will also be necessary to apply specific warning signs to indicate this condition, as required (in some countries) by the traffic regulations. When it is necessary to travel on roads, proceed as follows: 1 - Level the frame. 2- Select the TRAVEL operating mode (see «3.2.5 MACHINE CONTROLS» pos. 3 - OPERATING MODE SE- LECTION UNIT). 3 - Fold the front loader or the equipment-carrier completely, then raise the side stabilizers. 4 - If the machine is fitted with the front loader, apply the teeth guard.
5 - Lift the telescopic boom until the distance between the lowest point of the boom and the ground is approxi- mately 30 cm. 6 - Make sure that the work lights are off or at least covered by a screen. 7 - If required by the traffic regulations, operate the revolving light. 8 - Strictly respect the traffic regulations in force. 41