PRECAUTIONS TO BE TAKEN DURING WORK 2.4.3 CHECKS FOR TRAVELLING IN REVERSE. When operating in areas that may be hazardous or have poor visibility, designate a person to direct the movements of the ma- chine and traffic on the work site. Make sure that no unauthorized person is standing in the area or in the machine trajectory. If necessary, erect suitable fencing. Before moving the machine, warn the persons in the vicinity by sounding the horn. There are blind spots behind the machine, which cannot be seen and where someone may be standing: therefore, it is nec- essary to make sure that there is no one behind the machine before travelling in reverse.
2.4.4 MOVING THE MACHINE The machine must always be moved with the telescopic boom completely retracted and the equipment lowered until their distance from the ground is approximately 30 cm. The machine must travel with the frame in horizontal positions, in such a way as to be able to stand any inclina- tion due to the unevenness of the ground. When turning, make sure that there is a suitable distance between the machine and any wall or obstacle; when the machine is steering, in fact, the front equipment (and therefore the load) ( R1 ) and the rear part ( R2 ) of the machine protrude beyond the trajectory of the wheels ( R ).
When travelling with the TRAVEL-WORK mode selected, absolutely avoid lifting or extending the boom; this ap- plies both when the machine is loaded and when it carries no load. When travelling, always raise the stabilizers, if provided. Always travel at low speed, in particular on uneven, wet or irregularly compacted ground; if one of the wheels travels over an obstacle or gets into a hole in the ground, there is a serious risk of machine overturning. In these cases, travel very slowly and carefully while passing over the obstacle. 42 RKA01910 RKA01910