PRECAUTIONS TO BE TAKEN DURING WORK 2.4.9 MAIN OPERATING MODES After performing the checks regarding the safety conditions of the machine (cab or canopy, tyre pressure, sound- ness of the forks or equipment and of the fastening parts), always adopt the following procedure, with no excep- tion: 2.4.9.1 LOADING THE MATERIAL The operator must know or be able to estimate the weight of the load to be handled and its center of gravity. If the operator is not sure about these data, he must contact his supervisor or the supplier of the material to be handled.
Once the weight of the material has been determined, consult the machine load chart corresponding to the conditions of use (on tyres or stabilizers) and to the equipment fitted; this is important in order to en- sure that the lifting, transport and definitive positioning of the load are carried out within the safety range indicated (see «3.3.1 READING THE LOAD CHARTS»). 1 - Move the machine as near the load as possible, perpendicu- larly, without using the lifting equipment. 2 - If necessary, before starting the loading operations level the frame and make sure that the water level is centered. RKAA0532 46 ATTENTION