PRECAUTIONS TO BE TAKEN DURING WORK 3 - If the machine is equipped with stabilizers, lower them until raising the front tyres from the ground, keeping the frame lev- el. RKAA2240 4 - Adjust the equipment or the forks until they are perfectly lev- el; if the forks are used on loose loads, open them as much as possible to increase the stability of the load, or adjust them in order to center the wider part of the load to be han- dled. 5 - Slowly extend and lower the boom to take hold of the load with the equipment; the forks or other equipment must hold the load firmly and completely in the apposite areas.
6 - After making sure that the load is being held securely, fold the forks or the equipment completely to stabilize the load and maintain the center of gravity of the load in the pre- scribed position with respect to the forks. RKA01960 The load must be retained or released only through the movements of the boom; do not move the machine to take hold of the load or release it. Be extremely careful, in order to avoid moving the load. 8 - With lifted load, retract the telescopic boom to the travel posi- tion. 9 - Position the load at a distance of approximately 30 cm from the ground, raise the stabilizers completely and, travelling very slowly, move to the unloading area.
RKA01970 47 DANGER 7 - Slowly lift the load a few centimeters and make sure that it is level (center of gravity centered on the equipment). DANGER DANGER • If the shape of the load is irregular, or the center of gravity is offset, repeat the operations described above until centering the load perfectly. RKA02080