Komatsu — 2.5.2 THE ROUTE

TRANSPORTING THE MACHINE ON OTHER VEHICLES 2.5 TRANSPORTING THE MACHINE ON OTHER VEHICLES 2.5.1 LOADING AND UNLOADING THE MACHINE Loading and unloading the machine on/from another vehicle al- ways involve potential hazards; pay the utmost attention during the entire operation. Ramps Perform loading and unloading operations on firm, level ground; keep at a safety distance from the edges of ditches or from road sides. If the vehicles used have not been adequately equipped, put support blocks under the ramps, in order to prevent them from bending. Blocks Max. 15° !"#$ Blocks Always block the wheels of the transporting vehicle with wedg- es.

Always use ramps that are sufficiently wide and can support the weight of the machine. The longitudinal axes of the ramps must be parallel to each other and perpendicular to the loading board and their distance must be suitable for the tread of the machine. Make sure that the ramps are securely positioned and fastened to the loading board and that they have the same length. Position the ramps with a maximum inclination of 15°. Make sure that the ramp surface is clean and there is no trace of grease, oil, soil and ice; remove dirt from the wheels before starting to load the machine on the vehicle. Do not correct the trajectory of the machine while it is on the ramps.

If necessary, move it down the ramps and start the oper- ation again. When loading or unloading the machine, make sure that no part of the same gets in contact with the ground, the ramps, or the loading platform of the transport means. After loading the machine, make sure that the boom is com- pletely lowered and retracted; block its wheels with wedges and secure it with tie-downs or chains that prevent even any side- ward shift (see «3.9 TRANSPORTING THE MACHINE ON OTHER VEHICLES»). 2.5.2 THE ROUTE Define the route to be followed, taking in consideration the width, height and weight of the transport means and of the machine.

Make sure that the dimensions of the machine are compatible with the road and any galleries, subways, bridges, electric and telephone lines, etc. Keep to the regulations in force regarding the allowed width, height, weight of the machine and the transport speed. 53