PRECAUTIONS FOR EMERGENCY RECOVERY 2.7 PRECAUTIONS FOR EMERGENCY RECOVERY The machine must be towed by using a pin inserted in the appo- site rear hole and secured with safety pins (1). No special operations are required to tow the machine, provid- ed that the engine has been stopped. 1 Incorrect manoeuvres may cause serious damage, injury and even death. 2 To move the machine, use properly dimensioned steel cables (2); do not use worn cables or cables with broken strands, twist- ed cables, deformed cables. During the recovery operation, no one can be allowed to ap- proach the machines or the cables. RKAA2130 55 • Do not stand astride the cables.
• Move the machine only as far as necessary to allow the re- quired repairs to be carried out. • Do not remove the machine in any way other than that indicated in paragraph «3.14.2 REMOVING THE MACHINE IN CASE OF FAILURE». ATTENTION • The maximum force to be applied for towing the machine corresponds to 75% of the machine mass indicated on the identification plate. • Use cables of the same length and pull continuously, with- out jerking movements. • Position and connect the machine to be removed taking care that it is on the same axis as the towing vehicle; the traction force exerted must be parallel to the axis of move- ment of the machine. RKAA2140 ATTENTION