INSTRUMENTS AND CONTROLS 1 - GEARSHIFT-REVERSE LEVER Between the gearbox and the engine there is no mechani- cal connection; if the machine is parked on a slope, it can move freely even if the gears are engaged. For this reason, always apply the parking brake, in order to avoid serious damage. Before performing electric welding operations on the ma- chine, remove the guard and disconnect the connector of the gearshift-reverse lever (See «2.8.14 PRECAUTIONS CONCERNING THE GEAR LEVER»). Non-compliance with this rule may lead to serious damage, injury and even death, since the microcircuits of the selec- tion and storage of gears and of the travel direction may be irreversibly damaged.
It is a combined electronic control (1) that makes it possible to se- lect the machine travel direction, the gear and consequently also the travel speed. 1 2 The gearshift-reverse lever unit is available in two versions: STANDARD : manual shift of all gears. SEMI-AUTOMATIC : manual engagement of the first three gears and automatic management of 4 th and 5 th gear. The visual signals emitted by the led are the same and the only difference lies in the push button (2) (provided only for the semi- automatic version), which when pressed makes it possible to select the completely manual mode indicated by the coming on of the yellow led 7.
RKAA0960 It is possible to select among 5 FORWARD gears and 3 RE- VERSE gears. It is possible to choose among all the available gears only in TRAVEL operating mode. In TRAVEL - WORK operating mode only the 1 st and 2 nd forward and reverse (F - R) gears can be selected. In WORK operating mode the gearshift cannot be used. The start normally takes place in 2 nd gear, both forward and re- verse; it is possible to start in 1 st gear only by selecting it manual- ly. RKAA0790 84 DANGER