Komatsu — 3.2.5 MACHINE CONTROLS

INSTRUMENTS AND CONTROLS 2 - The engagement of a gear can take place only after the se- lection of the travel direction and within maximum 5 seconds; if the gears are not engaged, the gearshift returns to the safe- ty postion (NEUTRAL). 3 - The gears are engaged by rotating the lever on its axis and releasing it after each engagement. 4 - It is not possible to upshift from the 2 nd to the 3 rd FORWARD gear and from the 2 nd to the 3 rd REVERSE gear if the mini- mum number of revolutions necessary for upshifting hasn’t been reached. This doesn’t apply for the first two gears.

5 - The gearbox includes a device against quick shifting or re- versal manoeuvres that involve the risk of overspeed for the transmission; in this case the shifting control is stored, but the shifting isn’t carried out immediately; several gear shifts are carried out in 1.5 seconds, until the selected gear is en- gaged. Example If the machine travels in 2 nd forward gear at high speed and the 1 st gear is engaged, the leds are in the following condi- tion: led (1) is green and led (2) is green, but flashing: the flashing of the led signals to the operator that the speed must be reduced to allow the 1 st gear to be engaged.

The led of the upper gear flashes to signal that to shift down it is necessary to reduce the speed, while the led of the en- gaged gear remains steadily on. When the led stops flashing, this means that the selected gear has been engaged. 6 - The gears can temporarily be set to NEUTRAL (N) by using the transmission declutch button (1) positioned on the grip of the boom control lever, only in TRAVEL-WORK or TRAVEL operating mode. RKAA0810 RKAA0570 1 87