2.36 ELECTRICS SOLO CONTROL JOYSTICK The solo control joystick (1) is mounted, using four screws (2), on a moveable bracket (3) attached to a fixed bracket (4) on the right hand side of the operators seat. Removal 1. Disconnect the vehicle battery. 2. Remove the four screws (2) that hold the joystick to the cover pod (5). 3. Remove the three screws (7) and remove the cover pod over the joystick. 4. Disconnect the electrical connector (6) and remove the joystick from the bracket. Installation 1. Installation is the reversal of the removal procedure. 2. When fitting a new joystick ensure dipswitch settings are set to the correct positions before installation. 3. Reconnect vehicle battery. 4.
Operate the joystick to ensure that it functions correctly. NOTE: Ensure the invertor switches located on the base of the joystick are in the above position.