CLAAS ARGO K50, K60, K70 — SECTION 2 ELECTRICS

ELECTRICS 2.37 STARTER The starter motor (1) is a pre-engaged heavy duty type located on the inboard side of the engine. Removal Installation To remove the starter motor for the vehicle carry out the following procedure: Installation is the reverse of the removal procedure. NOTE: The sound proofing/underbody guard must be removed for access to the starter (from Machines S/ No.51200472 only). 1. Disconnect the vehicle battery. 2. From beneath the facia machine locate and remove the cable connections to the motor. 3. From above the engine remove the air cleaner assembly and the air induction tube to gain access to the upper mounting bolt of the motor. 4.

From beneath the machine remove the remaining motor retaining bolts, slide back the motor to disengage it from the drive ring and lower to ground. 5. Withdraw from beneath the machine.