. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 25 7. Remove the cloth or t ape cover installed 8. Check th at there is no dirt or oil stuck to t he seal portion of the new ele ment or clean ed element. Wipe off any dirt or oi 9. Push th e outer elem ent in straight wi leaner body. when nstalling it to the air c f the out er element is held and rocked lig htly up and dow n and o the lef t and right whi le pushing it in, the outer element c an be nserted Whe n insertin g the element, if the rubber at the tip is swollen or the outer element is not pushed in stra ight, and cover (3) is assembled by fo rce to hook (2), ther e is danger th damaged, so be careful when 10.
I nstall co ver (3) as foll ows. h the element. ook (2) to the protruding part of the air lock it in position. 1) Align 2) Hook clea 3) Whe on o as w 4) Whe betw If it is 1) Align cover (3) wit 2) Hook the tip of h ook (2) to the protr ner body and lock it in position. 3) Whe n locking hoo ks (2) in position, a pply the hooks i n turn pposite sides (top, bottom, left, ri ght) in the same way hen tightenin g bolts. is installed, check that the clearance 4) Whe n cover (3) een the air cle aner body and cov er (3) is not too l arge. too large, in stall again.