Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE failure of the engine. Do not use a screwdriver or other tool. 4 - 24 Never remove the inner elemen t (5). It will allow dirt to enter and cause 2. Hold the outer element (4) , move it carefully up and down and to the left and right, and ro while pulling it out. 3. After removing the outer tate the element to the left and right element, cover the air connector inside the air cleaner body dirt or dust from entering. with a clean cloth or tape to prevent 4. Use a brush or cloth to rem ove all the dirt stuck to cover (3) and the inside of air cleaner bo dy (6). r (Max. 0.69 MPa (7 kg/cm2, 99.4 5.

Direct dry compressed ai PSI)) from the inside of the direct the compressed air f again from the inside. 1) Check that the inner insert it securely. 2) If the yellow piston ov diameter immediately replace both the inner outer element along its folds. Then rom the outside along the folds, and element is not loose. If it is loose, erlaps the red zone (A) on the outer after the outer element is cleaned, and outer elements. NOTICE If small holes or thinner parts are f ound on the element when it is checked with an electric bulb after clea ning and d rying, r the element. t hit it or beat it against something. s or gasket or seal are damaged.

When cleaning the element, do no Do not use an element whose fold 6. If small holes or thinner p arts are found on the element when it is checked with an elec replace the element. tric bulb after cleaning and drying, NOTICE The inner element must not be cleaned and used again. When replacing the outer element, replace the inner element at the same time. If the inner element is not insta lled properly and the outer element and cover are installed, there is damaged. danger that the outer element will be be The seal portion on imitation p arts lacks precision, and allows the entry of dust, which leads to damage parts. of the engine. Do not use such imitation