Komatsu — REPLACE AIR CONDITIONER BELT

. MAINTENANCE SERVICE PROCEDURE any dirt stuck to the breather, then wash with clean diesel oil or flushing oil. 4 - 36 CLEAN FUEL TANK STRAINER t collected in it. Clean the str ainer if there is any dir t collected in it. Remove the If the strainer filler cap (1) of the fue is dirty, clean it with d l tank and take out strainer iesel fuel. DRAIN WATER AND SEDIMENT IN Carry out this procedure after the machine has be long time and after a long spell of r Loosen valve (1) at the bottom of th e fuel tank, and drain t he w ater and sedimen CLEAN STEERING CLUTCH CASE 1. Open the rear cover. 2. Remove 3. Remove bolts (1), then remove breather (3) on the sid REPLACE AIR CONDITIONER BELT 1.

Loosen 4 to the sid 2. Replace When directl 3. Tighten j V-belt. T (0.4 in) w kg) at a p pulley an 1. Loosen 4 bolts (1) and jack bolt (2), then move compresso r (3) e. the V-belt. adjusting the V-belt, do not push the compressor 2. Replace adjusting the V-belt, y with the bar. Use ja ack bolt (2) and bolts ck bolt (2). (1), and apply tension to the he standard deflectio n for the belt is approx . 10 mm hen pressed with a fi nger force of ap prox. 58.8 N (6 oint midway between the air condition er compressor d fan pulley.