. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN DAMPER CASE, CLEAN DAMPER BREATHER WARNING see dipstick (G). (F)Front of the machine 4 - 72 The oi l is at high te mperature immediately after th e machine h as b een operated.Wait for the oi l to cool down before carrying out maintenance. The undercover is h eavy. Do not go directly under t he cover when o pening or closing it. When r emoving bolts (4), carry out the operation at the rea r of the point im mediately unde r the cover so t hat it is possible to escape a t any time. Refill capacity: 1. 5 liters (0.40 U S gal) 1. Ope n the engine side cover on the lef t of the machine; you can 2.
Remove the und ercover (2) at t he bottom rea r of the chassi s as follows. 1) Remove 2 bolts (3) toward the front of the chassis. 2) Hold cover (1) and gradually remove 2 bolts (4) at the rear of the chassis. (Be careful when doing this. Rain water may run out.) 3) Lower cover (2) slowly and open it. Drain plug (P) can be seen at the top. follows. 1) Remove 2 b olts (3) toward the front of t he chassis 2) Hold cover ( 1) and gradual ly remove 2 b olts (4) at the rear of the chassi s. (Be careful w hen doing th is. Rain water may un out.) (2) slowly and open it. Drain plug (P) can be op. 3) Lower cover een at the t open it. Dra in plug (P) ca