. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE CHECK PIVOT BEARING OIL LEVEL, ADD OIL When removing plug (1), be careful not to let dirt or dust get it. 4 - 73 3. Remo ve dipstick (G), then r emove drain plug (P ) and drain the oil. After d raining th e oil,tighten drain plug ( 4. Add oi l through t he holder o f dipstick (G ). After addin g the oil, insert dipstick (G 5. Remo ve any dir t or dust stu ck to b reath er (5), t hen w ash w ith clean diesel oi l or flushi ng oil. cleaned completely, repl ace with a n ew pa 6. Install undercov er (2), then close e ngine side c over (1 ) on the left sid e of the m Remo When ve plug (1 removing 2.
Check that the o il is at the le vel shown in the dia gram. If the oil level ( 2) is low, a dd engine oil through th e hole of plu g (1). Use class CD S temperature. (B): 25mm (1inc