50 Disassembly and assembly SEN00949-00 Assembly a When installing floating seals, thoroughly clean, degrease, and dry the contact sur- faces of the O-rings and floating seals (hatched parts). Take care that dirt will not stick to the floating seal contact surfaces. a After installing the floating seals, check that their slant is less than 1 mm and their projection (a) is 7 – 11 mm. 1. Press fit 2 outer races (10) to roller (8). 2. Using push tool [3], press fit collar (12) to shaft (11). 4. Install floating seal (13) to the shaft. a For precautions for installation, see step 3. 5. Using push tool [4], press fit bearing (14) to the shaft. 3.
Using tool L3 , install floating seal (15) to collar (12). 6. Set shaft assembly (7) to block [5] and install roller (8). D65EX, PX, WX-15E0 21