Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — WHOLE DISASSEMBLY AND WHOLE ASSEMBLY OF TRACK SHOE ASSEMBLY

SEN00950-00 50 Disassembly and assembly 2) Operate the left cylinder to pull out the pin and bushing from the left link simultaneously. a Check the pulling out force of the pin and bushing to see if the necessary press fitting force for the pin and bushing can be obtained when reversed and assembled again. 3. Inspection Check the parts for the following items to see if they can be used for a lubricated track or a grease-filled track, then examine them gener- ally and determine to use them for a lubricated track or grease-filled track. a For judgment of reuse of the parts, see “Guidance for reusable parts, Lubricated tracks”. 1) Check the parts visually for damage.

If a part seems to be damaged, check it by dye penetrant test or magnaflux inspec- tion. If it has any crack, it cannot be used again. Discard it. 3) Return the left cylinder and operate the right cylinder to pull out the pin and bush- ing from the right link simultaneously. 2) Measure the outside diameter of the press fitting parts of the pin and bushing and the inside diameter of the pin and bushing fit- ting parts of the link with a micrometer and a cylinder gauge to see if the allowable fit- ting allowance is obtained. When using the pin, bushing, and link for a lubricated track, however, secure the standard fitting allowance between the pin and link.

a If the allowable fitting allowance is not obtained, replace the parts with new ones. a For the dimensional criteria, see Structure, function and maintenance standard, "Track shoe." 4) Return the right cylinder and take out the links, pins, bushings, and spacers on both sides and feed the next 1 set of the link assembly to the jaw. a If the bushing ends and sealing sur- faces are damaged, oil will leak. Accordingly, handle them carefully. 6 D65EX, PX, WX-15E0