Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — WHOLE DISASSEMBLY AND WHOLE ASSEMBLY OF TRACK SHOE ASSEMBLY

50 Disassembly and assembly SEN00950-00 5) Installation of seal assembly Clean and degrease parts (b) indicated with thick lines (the counterbore portion of the link and seal assembly) carefully. Then, using tool R6 , push in the seal assembly to the bottom. a If oil or grease is sticking to the coun- terbore portion of the link or seal assembly, the seal will turn and its sealing performance will lower. Accordingly, do not apply any oil or grease to that portion. 7) Adjust the relief pressure of the link press so that the pressing force of the press will not exceed the standard value. a If the pressing force is too strong, the spacer will be pressed forcibly against the bushing.

As a result, the spacer may be broken and it and bushing may be worn abnormally. a Pushing force of pin and bushing: 539 kN {55 tons} Pushing force 1.8 x Average pressure (Adjust the relief pressure of the link press to set the press cutting force.) 6) Adjust the dimensions of the press fitting jig of the link press to keep the projection of the pin and bushing constant and keep the installed dimensions of the seal within the standard range. 2. Assembly of link 1) Apply oil (GO90) to the mating surfaces of the pin and bushing with a clean brush and assemble them, then set them before the jaw of the link press.

a When reusing (reversing) the bush- ing, set the worn outside surface of the bushing on the shoe fitting side of the link (set the bushing with the worn outside surface up on the link press). q Dimension c: 3 mm d: 3 mm e: 49.7 mm a If the pin end (part f ) or link sides (parts g and h ) are worn, add the dimensions of the worn parts when adjusting the standard dimensions so that the projections of the pins and bushings on both sides will be even. 2) Press fit the master links on both bushing sides to the bushing with the shoe fitting faces up. a At this time, use the master links on the pin side as supports. a Set the link receiving face of jaw [4] vertically.

a Wear plate [5] should be a replace- able one, if possible. D65EX, PX, WX-15E0 9