SEN00950-00 50 Disassembly and assembly a Press fitting force for bushing: 98 – 147 kN {10 – 15 tons} 6) Send the master links and set the next pin and bushing. a When reusing a pin, install it so that its side hole (i) will be the link tread side similarly to a new one. a If it is not installed so, its strength may be lowered. Accordingly, indicate the direction of the side hole on the end face to prevent a mistake. 3) Using the shoe bolt hole pitch gauge, press fit the master links until the distance between the shoe bolt holes of both links is the standard value. a Remove the all steel chips caused by press fitting of the bushing with com- pressed air.
4) Turn over the master links and check that they are press fitted in parallel. 7) Set the right link and install the spacer to the pin. a Check that the seal surface and bush- ing end are free from dirt and apply oil (GO90) to them with a clean cloth or brush. a When installing the spacer, wipe it with a clean cloth. 5) Measure the projections of the bushing on both sides with a depth gauge. a Adjust the press fitting jig of the link press so that the projections on both sides will be even. 8) Set the right jig on the receiving side and the left one on the pushing side and press fit the pin and bushing simultaneously.
a If the pin and bushing have play when they are press fitted, the seal may come off the link. To prevent this, press fit smoothly. a If the seal comes off the link, stop press fitting and set the seal to the link correctly, then start press fitting again. 10 D65EX, PX, WX-15E0