SEN00950-00 50 Disassembly and assembly 8. Vacuum test Using hand vacuum pump [3], remove the air from the small plug hole at the end face of pins (1) and (2) and check the sealing performance. a Check that the airtightness is maintained for 5 seconds at a negative pressure of 92.7 ± 1.9 kPa {695 ± 15 mmHg}. 2) Using tool R4 , drive in the small plug to the following depth quickly. a Coat the outside circumference of the small plug with oil (GO140B). q Depth to drive from end face: 2.5 ± 1 mm 9. Charging with oil 1) Using tool R7 , charge with oil (GO140B) through the small plug hole in the pin. a Be careful not to raise the pressure too high when charging with oil.
This will have an adverse effect on the seal. a Take into consideration the expansion of the oil under heat, and be careful not to charge with too much oil. 26 D65EX, PX, WX-15E0