50 Disassembly and assembly SEN00953-00 a Install seal without gap at the seal joint posi- tions. 3. When installing the operator’s cab, obey the following points. 1) Lower the operator’s cab assembly onto the floor frame slowly. a Since the reaction force of the seal sponge is large, lower the operator’s cab assembly slowly. a Check that the air conditioner duct seal on the cab side is tightly in con- tact with the air conditioner duct on the dashboard side and there is not clearance. a Since the clearance between the air conditioner duct on the cab side and the monitor is narrow, lower the oper- ator’s cab assembly carefully. 2) Tighten the mounting bolts temporarily.
3) Check that the seal between air condi- tioner bracket (23) and cab (22) is fitted securely. 4) Check that there is no clearance at joint (a) of the seal and floor frame. q Details 1) Make the end face of seal (C) with the wall without any gap. (See the diagram above for A portion.) 2) Before cutting the end of (C), adhere seal (D) to the groove, then adhere seal (E). a Check that the ends of (D) and (E) have no gap between (C). 3) Cut seal (C) at a position where it is flush with seal (E). a Use remaining portion of seal (E) as seal (F). D65EX, PX, WX-15E0 7