SEN00953-00 50 Disassembly and assembly 3) Fill the clearance between each door win- dow glass and trim in the range of dimen- sion (k). 1] Mask the range of dimension (k) of each door window glass. 2] Fill clearance (m) between each door window glass (2) and trim seal (4) with caulking material. a The using limit of the caulking mate- rial is 6 months after the date of man- ufacture. Do not use the caulking material after this limit. a Apply the caulking material to joint (c) of the trim seal, too. 9. Fix the window glasses. 1) Using styrene foam blocks [10] and rubber bands [11], fix the front window glass to fit it completely. a You may use sealing tapes to fix the front window glass.
(The figure shows the operator’s cab of a hydraulic excavator.) 2 Caulking material: SEKISUI SILICONE SEALANT 2) Immediately after sticking both door win- dow glasses, install door handles (5) and fix the glasses. 10. After installing the window glasses, remove the primer and adhesive from them and the opera- tor’s cab. a Using white gasoline, wipe off the adhe- sive before it is dried up. a When cleaning the glasses, do not give an impact to them. 11. Protect the stuck window glasses. 1) Keep the stopper rubbers, styrene foam blocks, and rubber bands installed for 10 hours (at temperature of 20єC and humid- ity of 65%).
2) After applying the adhesive, wait for at least 24 hours, before operating the machine actually. 16 D65EX, PX, WX-15E0