SEN00283-01 10 Structure, function and maintenance standard Outline Bevel gear shaft q Bevel gear shaft converts power sideways at a right angle, which is transmitted from engine to torque converter and transmission through mesh of bevel pinion (31) and bevel gear (19). It also reduces the rotation speed. Brake q Brake is established to control the movement of the machine, and is attached to brake hub (14). q Brake adopts wet multiple disc clutch type and spring-boosted type, and it is hydraulic actu- ated type which activates brake valve (1) by the operation of brake pedal.
q Bevel gear shaft adopts spiral bevel gear at bevel pinion (31) and bevel gear (19), and it adopts splash lubrication with oil from scav- enging pump and lubrication pump for lubrica- tion. q It adopts forced lubrication which sends oil from scavenging pump and lubrication pump to cover (10) and cage (8) through passage inside steering case, and then to disc (12) and plate (11). q Bevel gear shaft consists of bevel gear (19) which meshes with bevel pinion (31), bevel gear shaft (18) and bearing (20) which sup- ports bevel gear shaft and cage (16).
q When the engine is stopped, back pressure of brake piston (9) descends even if the brake pedal is not depressed, which initiates the brake to “operate“. However, parking brake lever must be in “lock“ position, because the brake is “released“ as the oil pressure within the circuit rises when the engine is restarted. HSS q HSS is constructed from transfer area which transmits rotation of HSS motor (2) by turning it in reverse direction, and the planet area which adjusts inputs to ring gear (24) and gear A (15) and then outputs to carrier (27).
It changes the turning direction of the machine by turning off the rotation of HSS motor (2), or by making it move in normal rotation or reverse rotation. q Brake is constructed from; carrier (27), brake hub (14) attached to hub (7), disc (12) meshed with brake hub, plate (11) whose outside perimeter is attached to brake drum (13) with gear, piston (9) and springs (4) and (5) which brings disc and plate together, and cage (8), cover (10) and output shaft (3) which supports all of them. Brake drum (13) and cover (10) are fixed to the steering case. Also, output shaft (3) is connected to the hub (7) by spline and held by spacer (6) in the axial direction.
q The transfer unit employs a spur gear speed reduction mechanism and is lubricated with oil splashed by the scavenging pump and lubrica- tion pump. q Planet area adopts forced lubrication with oil from scavenging pump and lubrication pump for lubrication. q Transfer area is constructed from; HSS motor drive gear (30) attached to HSS motor (2) with spline, gear D (29) meshed with HSS motor drive gear, gear C (22) meshed with gear D, gear B (17) attached to shaft (21), gear A (15) retained on bevel gear shaft with bearing, gear A (15) meshed with gear D (29) and case which supports them all.
q Planet area is constructed from; gear A (15), planetary pinion (23), pinion shaft (25), hub (26) attached to bevel gear shaft (18) and ring gear (24) with gear, and carrier (27) attached to brake hub (14). 10 D65EX, PX, WX-15E0