Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — HSS MOTOR

10 Structure, function and maintenance standard SEN00285-01 Operation 1. Operation of motor q The pressurized oil sent from the pump enters cylinder block (5) and pushes piston (4) from the back face. 2. Rotation speed and torque control q As flow (Q) from the HSS pump is increased, motor speed (N) is heightened. q In the case of the motor, the center line of plate (3) is always at an angle (swash plate angle ( α )) to the axial direction of cylinder block (5). q Since the swash plate angle of the HSS motor is fixed ( α is constant), rotating torque (T) is proportional to pressure (P). q Swash plate angle ( α ) is approx. 19°.

q As a result, if we take the example of one of pistons (4), the oil pressure is applied to the back face of the piston, and the piston axial force (FO) is generated. Q = qN (q = E – F) q With shoe (16), which is joined to piston (4) by the spherical surface, reaction force (FR) in a direction at right angles to flat surface (A) is generated. The combined force of (FO) and (FR) is (FP) and this becomes the force to rotate cylinder block (5). T = Pq/2 x Q:Total flow q: Flow per 1 turn N:Rotation speed P: Pressure T: Rotating torque q Shaft (1), which is meshed to cylinder block (5) by spline (15) transfers this rotating torque to the output side.

q Cylinder block (5) rotates, and while the condi- tion changes from volume (E) to volume (F), pressurized oil from the pump flows into the cylinder chamber, and pressure (P) is gener- ated according to the load. q On the other hand, when the condition goes beyond volume (F) and changes to volume (E), the oil is pushed out and returned to the pump. D65EX, PX, WX-15E0 31