Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — PPC VALVE (BLADE LIFT, BLADE TILT)

10 Structure, function and maintenance standard SEN00287-01 5. When blade is operated to "Float" 6. When blade is released from "float" q When piston (4) at port (P1) “lower“ side is pushed by disc (5) and moves down, ball (11) contacts protrusion (a) of the piston during the stroke. [Detent starts to act] q When disc (5) is returned from the “float“ posi- tion, it is pushed down by a force greater than the hydraulic force in chamber (E). q When piston (4) is pushed in further, ball (11) pushes up collar (12), which is being held by detent spring (13). While pushing up collar (12), it escapes to the outside and passes over protrusion (a) of the piston.

q As a result, chamber (E) is shut off from pas- sage (d) and is connected to the drain cham- ber. Therefore, the oil pressure inside chamber (E) is lost, and the “float“ position is canceled. q When this happens, piston (4') on the opposite side is pushed up by spring (14). q As a result, the oil inside chamber (F) passes through (b) and (c), and flows to chamber (E), and piston (4') follows disc (5). Passage (d) is connected to port (P1), so more or less the same pressure is applied as is applied to port (P1).

q Chamber (E) is normally connected to drain chamber (D), but if ball (11) passes over pro- trusion (a) of the piston, passage (d) and chamber (E) which were shut off, are con- nected and the pressure oil flows. q At the same time, the control valve also moves to “float“ position and the circuit is set to the “float“ condition. q Piston (4') is being pushed up by the oil pres- sure inside chamber (E), so even if the lever is released, it is held at the “float“ position. D65EX, PX, WX-15E0 7