10 Structure, function and maintenance standard SEN00290-01 Processing in monitor panel (Common to all specifications) Display of monitor panel Display of monitoring a For details of the operating method, see Testing and adjusting, “Special functions of monitor panel (EMMS)”. Other items a For details of the operating method, see Testing and adjusting, “Special functions of monitor panel (EMMS)”. D65EX, PX, WX-15E0 3 Contents and conditions of processing Method Flow of signals 1. Display of travel direction and gear speed • Signals (F1, R3, etc.) are sent to the monitor panel according to the information of the transmission and steering controller.
CAN signal Each sensor/solenoid O Controller O Monitor panel 2. Display of engine speed, coolant temperature, hydraulic oil tempera- ture, power train oil temperature, and fuel level by gauge • The controller processes the sensor signals and converts them into gauge levels and sends the result to the monitor panel. CAN signal 3. Display of trouble • If there is any trouble, its failure code signal is sent to the monitor panel. • Information about sounding the buzzer and flashing the caution lamp is sent, according to the contents of the trouble. 1) In normal state An action code is displayed.
2) In failure history display mode A failure code (6-characteristics code) and the following are dis- played. • Elapsed time after first occurrence • Elapsed time after latest occurrence • Number of occurrence CAN signal Contents and conditions of processing Method Flow of signals 1. Display of each sensor, each solenoid, communicating state of CAN signal, etc. • The signals of the item No. and condition of each device are sent to the monitor panel. CAN signal Each sensor O Controller O Monitor panel 2. Selection of each item with information switch, buzzer cancel switch, and up/downs (gear-shift) switch of the steering/directional/gear shift lever.
(When using a mode for service, turn the service switch ON.) CAN signal Contents and conditions of processing Method Flow of signals 1. Filter and oil maintenance mode 2. Pm clinic auxiliary mode 3. Failure code display mode 4. Adjustment mode (User) 5. Maintenance interval change mode 6. Electric system failure code display mode 7. Mechanical system failure code display mode 8. Adjustment mode (Service) 9. Load saving display mode 10. Real-time monitoring mode 11. Dual display monitoring mode CAN signal Each sensor O Controller O Monitor panel