10 Structure, function and maintenance standard SEN00290-01 Buzzer cancel switch q If the switch is operated while the alarm buzzer is sounding, the buzzer is turned off tempo- rarily. While the buzzer is turned OFF, if a new trou- ble which turns on the buzzer is detected, the buzzer sounds again. a The lamp lights up and goes off at the intervals of about 0.8 seconds. a The flashing intervals of the lamp may change a little when the temperature is low (below about –10°C). This does not indicate a trouble. Input and output signals AMP070-20P [CN-S03] AMP070-12P [CN-S04] D65EX, PX, WX-15E0 5 Pin No.
Signal name Input/Output signal 1 Power source (24 V) Input 2 Power source (24 V) Input 3 GND — 4 GND — 5 Constant power source (24 V) Input 6 Constant power source (24 V) Input 7 Starting switch (C) Input 8 Night lightning Input 9 Preheating Input 10 NC — 11 NC — 12 NC — 13 NC — 14 NC — 15 NC — 16 Service switch Input 17 NC — 18 Alarm buzzer Output 19 NC — 20 NC — Pin No. Signal name Input/Output signal 1 CAN0-H Input/Output 2 CAN0-H Input/Output 3 CAN0-L Input/Output 4 CAN0-L Input/Output 5 CAN shield — 6 NC — 7 NC — 8 NC — 9 Alternator (R) Input 10 Fuel level Input 11 NC — 12 Power train oil temperature Input