30 Testing and adjusting SEN00585-00 Measuring intake air pressure (boost pressure) 1 4. Run the engine at medium or higher speed and drain the oil from the hose. a Insert the joint of the gauge and hose half- way and open the self-seal on the hose side repeatedly, and the oil is drained. a If Pm kit (A) is available, the air bleeding coupling (790-261-1130) in it may be used. a If any oil is left in the hose, the gauge does not move. Accordingly, be sure to drain the oil. a Measuring instruments for intake air pressure (boost pressure) k When installing and removing the measur- ing instrument, take care not to touch a hot part of the engine.
a Measure the intake air pressure (boost pres- sure) under the following condition. 5. Measure the intake air pressure (boost pres- sure) while the engine is running at high idle and the torque converter is stalling. a For the procedure for stalling the torque converter, see “Measuring engine speed”. a Normally, the intake air pressure (boost pressure) should be measured while the engine is running at the rated output. In the field, however, an approximate value can be obtained by stalling the torque con- verter. q Coolant temperature: Within operating range q Hydraulic oil temperature: Within operat- ing range q Power train oil temperature: Within operat- ing range 1.
Open the left side cover of the engine. 2. Remove air intake connector boost pressure pickup plug (1). 6. After finishing measurement, remove the mea- suring instrument and reinstall the removed parts. 3. Install nipple [1] of boost gauge kit A and con- nect gauge [2]. D65EX, PX, WX-15E0 7 Symbol Part No. Part name A 799-201-2202 Boost gauge kit