SEN00585-00 30 Testing and adjusting 6. While the No.1 cylinder is at the compression top dead center, adjust the clearance of valve marked with q in the valve arrangement figure. 5) While the No. 6 cylinder is at the compres- sion top dead center, adjust the clearance of valve marked with Q in the valve arrangement figure. a Procedure for the adjustment is as same as 1) – 3). 7. Adjust the valve clearance in the following pro- cedure. 1) Insert clearance gauge D2 into the clear- ance between rocker lever (21) and cross- head (22). 2) Loosen locknut (23) and adjust valve clearance with adjustment screw (24).
a With the clearance gauge inserted, turn the adjustment screw so that you can move clearance gauge D2 lightly. 3) Fix adjustment screw (24) and tighten locknut (23). 8. After finishing adjustment, reinstall the removed parts. [*1] 3 Air intake connector hose clamp bolt: q Radiator side 10.5 ± 0.5 Nm {1.07 ± 0.05 kgm} 3 Locknut: 24 ± 4 Nm {2.4 ± 0.4 kgm} a After tightening the locknut, check the valve clearance again. q Turbocharger outlet side tube clamp bolt 7 ± 1.1 Nm {0.71 ± 0.11 kgm} [*2] 3 Air cleaner air intake hose clamp bolt: 10.5 ± 0.5 Nm {1.07 ± 0.05 kgm} [*3] 3 Air cleaner mounting band bolt: 9.8 – 11.8 Nm {1.0 – 1.2 kgm} [*4] 3 Cylinder head cover mounting bolt:
11.8 ± 1.96 Nm {1.2 ± 0.2 kgm} 4) After finishing the adjustment of all valves marked with q , turn the crankshaft 360° forward and align stamp line ( c ) of the front gear cover and stamp line of supply pump gear ( b ). a The No.6 cylinder comes to the com- pression top dead center position. 14 D65EX, PX, WX-15E0