Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — MEASURING COMPRESSION PRESSURE

30 Testing and adjusting SEN00585-00 Measuring compression pressure 1 a Measuring instruments for compression pres- sure k When measuring the compression pres- sure, take care not to burn yourself on the exhaust manifold, muffler, etc. or get caught in a rotating part. a Measure the compression pressure after the engine is warmed up. (Engine oil temperature: 40 – 60°C) 5. Loosen injector harness terminal nut (7) and disconnect the terminal from the injector. 6. Set the cylinder to be inspected to the com- pression top dead center. a Refer to “Adjusting valve clearance”. 1.

Refer to steps 1, 2, and 8 of “Adjusting valve clearance” to remove and install the engine hood assembly, air cleaner assembly and muf- fler assembly. 7. Remove rocker arm assembly (8). 2. Disconnect breather tube (1) and blow-by tube (2) and remove cylinder head cover (3). 8. Remove crosshead (9). 3. Disconnect injector harness (4). (3 places) a Make notes of the installation positions and hole shapes of ( a ) and ( b ) sections. (So that the removed parts can be rein- stalled to their original positions later.) 4. Disconnect fuel high-pressure pipe (5). a Before disconnecting pipes No.1, 3, and 5, disconnect harness connector (6) from the block. D65EX, PX, WX-15E0 15 Symbol Part No.

Part name E 1 795-799-6700 Puller 2 795-502-1590 Gauge assembly 3 795-790-6110 Adapter 4 6754-11-3130 Gasket