Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — MEASURING COMPRESSION PRESSURE

SEN00585-00 30 Testing and adjusting 9. Remove retainer (10) to dismount inlet connec- tor (11). 12. Install gasket E4 to the top of adapter E3 and insert adapter into mounting section of the injector. k Remove the dusts around the inlet con- nector thoroughly in advance to pre- vent them from entering the cylinder head hole or the inlet connector during the removal operations. 13. Fix adapter E3 with holder (13). a Tighten bolts (12) diagonally so that the upper surface of holder (13) becomes par- allel to the upper surface of the cylinder head. 10. Unscrew bolt (12) to remove holder (13). q Maximum angle limit: 2.4° 3 Bolt: 9.8 ± 2.0 Nm {1.0 ± 0.2 kgm} 14.

Connect gauge assembly E2 to adapter E3 . a Leakage can be prevented by applying a little amount of engine oil to the fitting faces of the adapter and gauge. 11. Remove injector (14) with puller E1 . a Do not ply the upper part of the injector to remove it without using puller E1 . 15. Install rocker arm assembly (8). 3 Rocker arm assembly mounting bolts: 64.7 ± 4.9 Nm {6.6 ± 0.5 kgm} 16. Install crosshead (9). 17. Adjust valve clearance. a Refer to “Adjusting valve clearance”. 16 D65EX, PX, WX-15E0