Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — MEASURING BLOW-BY PRESSURE

30 Testing and adjusting SEN00585-00 Measuring blow-by pressure 1 5. Measure the blow-by pressure while the engine is running at high idle and the torque converter is stalling. a For the procedure for stalling the torque converter, see “Measuring engine speed”. a Normally, the blow-by pressure should be measured while the engine is operated at the rated output. In the field, however, an approximate value can be obtained by stalling the torque converter. a If it is impossible to run the engine at the rated output or stall the torque converter, measure while the engine is running at high idle. The value obtained in this case is about 80% of the blow-by pressure at the rated output.

a The blow-by pressure may vary largely with the engine condition. If the measured value is judged abnormal, check for increase of oil consumption, bad exhaust gas color, premature deterioration or con- tamination of oil, etc. which are related to the abnormal blow-by pressure. a Measuring instrument for blow-by pressure a Measure the blow-by pressure under the fol- lowing condition. q Coolant temperature: Within operating range q Hydraulic oil temperature: Within operat- ing range q Power train oil temperature: Within operat- ing range 1. Open the left side cover (1) of engine hood and remove side cover (3). 2.

Remove the mounting clamp of blow-by hose (4) on the engine side and pull out the hose to the left outer side of the engine. 3. Install blow-by tool F2 to blow-by hose (4). 4. Install hose [1] of blow-by checker F1 to blow- by tool F2 and connect them to gauge [2]. 6. After finishing measurement, remove the mea- suring instrument and reinstall the removed parts. D65EX, PX, WX-15E0 19 Symbol Part No. Part name F 1 799-201-1504 Blow-by checker 2 795-790-3300 Blow-by tool