30 Testing and adjusting SEN00585-00 Handling of fuel system devices 1 Releasing residual pressure from fuel system 1 a Precautions for testing and maintaining fuel system The common rail fuel injection system (CRI) consists of more precise parts than the con- ventional fuel injection pump and nozzle. If for- eign matter enters this system, it can cause a trouble. When testing and maintaining the fuel system, take care more than the past. If dust, etc. sticks to any part, wash that part thoroughly with clean fuel. a Precautions for replacing fuel filter cartridge Be sure to use Komatsu genuine fuel filter car- tridge.
Since the common rail fuel injection system (CRI) consists of more precise parts than the conventional fuel injection pump and nozzle, it employs a high-efficiency special filter to pre- vent foreign matter from entering it. If a filter other than the genuine one is used, the fuel system may have a trouble. Accord- ingly, never use such a filter. a Pressure is generated in the low-pressure cir- cuit and high-pressure circuit of the fuel sys- tem while the engine is running. Low-pressure circuit: Fuel pre-filter – Lift pump – Fuel main filter – Fuel supply pump High-pressure circuit:
Fuel supply pump – Common rail – Fuel injector a The pressure in both low-pressure circuit and high-pressure circuit lowers to a safety level automatically 30 seconds after the engine is stopped. a Before the fuel circuit is tested and its parts are removed, the residual pressure in the fuel cir- cuit must be released completely. Accordingly, observe the following. k Before testing the fuel system or removing its parts, wait at least 30 seconds after stop- ping the engine until the residual pressure in the fuel circuit is released. (Do not start the work just after stopping the engine since there is residual pressure.) D65EX, PX, WX-15E0 21