SEN00585-00 30 Testing and adjusting Testing fuel pressure 1 2) Install adapter H2 to plug hole, and con- nect fuel vacuum gauge H4 . a Measuring tools for fuel pressure a Tests only the fuel pressure in negative pres- sure circuit from fuel supply connector to lift pump inlet, and in low-pressure circuit from lift pump to fuel main filter and supply pump. 3) Run the engine at high idle and test the fuel negative pressure circuit pressure. a If the fuel negative pressure circuit pressure is in the following range, it is normal. k Since the pressure in the high-pressure cir- cuit from fuel supply pump to common rail and fuel injector is very high, it cannot be measured.
q Standard value of fuel negative pres- sure circuit pressure (fuel supply con- nector): Max. 27.1 kPa {Max. 203 mmHg} 1. Open the left cover of engine hood. 2. Testing fuel negative pressure circuit pres- sure (fuel supply connector) 1) Remove fuel pressure pickup plug (1) from the fuel supply connector. 4) After finishing testing, remove the testing tools and return the removed parts. q Fuel pressure pickup plug: 20 – 22 Nm {2.0 – 2.2 kgm} 3. Testing fuel negative pressure circuit pres- sure (supply pump) 1) Remove fuel pressure pickup plug (2) from the supply pump. 22 D65EX, PX, WX-15E0 Symbol Par t No.
Part name H 799-1 1 790-2 01-5002 Hydrauli c tester 61-1204 Digital ty pe hydraulic tester 6732- 2 6215- Adapter 81-3170 (10 x 1.0 mm o R1/8) 81-9710 O-ring 3 799-4 Hydrauli 01-2320 0.98 MP c tester: a {10 kg/cm2} 4 799-2 01-1201 Fuel vac uum gauge