Komatsu D65EX-15E0, D65PX-15E0, D65WX-15E0 — TESTING FUEL PRESSURE

30 Testing and adjusting SEN00585-00 2) Install adapter H2 to plug hole, and con- nect fuel vacuum gauge H4 . 2) Install adapter H2 and nipple [1] of hydraulic tester H1 to plug hole, and con- nect hydraulic tester H3 . 3) Run the engine at high idle and test the fuel negative pressure circuit pressure. a If the fuel negative pressure circuit pressure is in the following range, it is normal. 3) Measure fuel low-pressure circuit pres- sure when cranking the engine. a If the fuel low-pressure circuit pres- sure (at the fuel filter inlet side) is in the following range, it is normal. q Standard value of fuel negative pres- sure circuit pressure (supply pump): Max. 33.9 kPa {Max.

254 mmHg} q Standard value of fuel low-pressure circuit pressure (fuel filter inlet side): Min. 69 kPa {0.7 kg/cm 2 } 4) After finishing testing, remove the testing tools and return the removed parts. k For protection of the starting motor, do not continue cranking for 30 seconds or more. q Fuel pressure pickup plug: 20 – 22 Nm {2.0 – 2.2 kgm} 4. Testing fuel low-pressure circuit pressure (fuel filter inlet side) 1) Remove fuel pressure pickup plug (3) from the fuel main filter inlet side. 4) After finishing testing, remove the testing tools and return the removed parts. q Fuel pressure pickup plug: 20 – 22 Nm {2.0 – 2.2 kgm} D65EX, PX, WX-15E0 23